Questions and discussion about solar, batteries, and electrification
Can anybody tell me why I show that I am drawing from the grid AND exporting at the same time in the middle of the day. Was changed over to NET metering a couple of months ago.
Seems like a way for AGL to make money, Charge for power at a high cost and give me a lttle money for the export at the same time, when I should be using all my solar and not drawing from the grid.
Please explain???
Or would this just be a technical difficulty the AGL have every day with everything?
Check with whom ever installed your solar and make sure they have connected to all circuits, maybe they could not connect to all of them and so one is pulling from the grid whilst the others are covered by the solar.
eg. power and lights circuits hooked to solar but maybe shed is not.
this turned out to be the issue I had, no room to connect to all of house so they connected just to shed circuit with pool pumps as they used the most power
Smart Meters are smart.
For instance if you have excess solar generation,it will flow through the Export side of the meter, if you do not have enough generation, power from the grid flows through the import side of the meter.
When installing Solar the only connection you need to make is to connect the Solar output to the main circuit board.
The only reason they connected to the shed was that there was no room to add another circuit into the board and used the shed circuit to get the power BACK to the main board. The shed should have been wired with heavier wiring anyway.
So in your case the Solar Circuit Breaker will be located in your Shed and the Main Solar AC Solar Switch on the wall next to the inverter.
In the Main Supply Board (Meter Box), there should be an tag indicating that Solar Circuit Breaker is located in the Shed Sub Board and that the Solar AC Switch located next to the inverter.
The instruction for your Solar should indicate that to isolate the solar you need to :
To turn back on, reverse the the process, DC On, Main AC back on.
Once again I will iterate that it is possible to EXPORT and IMPORT, you can never do this at the SAME time (your time is in milliseconds) but remember your INTERVAL METER (Smart Switch) supplies readings at intervals (30, 15 or 5 min are common).
In 30 min intervals you will see it more often than 15 or 5, but it will occur.
You can see above when I was exporting / exporting on the 29th July 2023.
The 5min interval readings are supplied to me by SA Power Networks
The 30min readings are supplied from My Account at AGL.
I deliberately picked this day as it was clearly overcast as I generally don't import any power from 08:00 till 17:00 on most days, but then we only consume round 5kWh a day any way. The higher you usage the more chance you will get of using all of your solar.
Above is Screen Report for running my program to convert the AGL data into a NEM 12 format file. My data from SA Power Networks is supplied in NEM 12 format.
Note that I also only use meter readings based on my consumption for the Bill, I gave up actually reading my meter, a long time ago as it has been reset many times.
You will also need to note that the New Look AGL Bill DOES NOT CONTAIN meter readings, ONLY YOUR CONSUMPTION for the billing period.
Above is the results so far for my current billing cycle (in my Plan Schedule), you can see why power is cheaper in Shoulder Rate... My HIGH usage (3%) of shoulder power is because I heat my hot water during this period...
And here is my projected bill, I pay $22.50 every fortnight, so I don't get billshock.
The answer is simple, I have a heat pump Hot Water Service.
I simply set the time for it to turn on when ever I want, in my case its from 10:30 and 17:00 even though most days it has heated the water to 66deg C by 13:30. (Less in Summer as the inlet water temperature is warmer)
You may be able to obtain a FREE HEAT PUMP for your place.
Also, there are three controlled load Tariffs that are available now, a solar sponge Tariff is available.