I have recently got my gas bill back at over $500, for a two person household that only uses gas to heat up our water. It is only a small hot water system too so we only get 5 min showers.
When I called up to get help, I was told that it was correct and my previous bills which I have two of at $120 each were wrong. I have consulted a plumber who has informed me that something is wrong and the bill doesn't look right. I cannot smell any gas near the meter either, but a bill of that size does not make sense for the amount of gas we use.
After reading online that this has happened to many people, and that AGL are never helpful it has worried me and I have seriously considered changing companies.
Is there anything I can do about this?
Welcome to the AGL Community!
When investigating a high bill, the following suggestions are a good start:
Our meter is more, however it is continuously rising even though we are not using the gas. Even as I look at it, after being out all day, the numbers change.
Our last two bills were actual readings. Before that we were not at the property.
We only use gas gas for hot water as I mentioned previously. We have gas points but they are not used and never have been used while we have been at this property.
I have seen that my town has had a lot of complaints surrounding this issue this month and the reason being that AGL has hired someone who gave incorrect readings and refuse to fix it.
Thank you for getting back to me!
If your current meter reading is higher then that listed on your bill, then this rules out the possibility of the meter being misread by your meter reader. If you have already had a plumber attend and you have not noticed any obvious smells of gas around the property, then it may be necessary to have your meter tested. Unfortunately we can't arrange this through the AGL Community, but our customer service team can arrange this for you who can be contacted here.
Please let me know if there is anything else that I can clarify for you.
No problems at all!
If your meter is found to be faulty, then any bill(s) impacted by this fault will be adjusted using historical usage data and/or usage data obtained from your new meter.